Steady-state concentrations across dose tiers — anyone have experience?

Answering the narrow version, because the broad one does not have a single answer. Do it in two steps and it stops being confusing. First concentration: 10mg into 2ml is 5mg/ml. Then volume: a 0.5mg dose is 0.5 ÷ 5 = 0.1ml. Then units, and this is where people go wrong — a U-100 syringe is graduated in hundredths of a millilitre, so 0.1ml is 10 units. The word "units" has nothing to do with milligrams; it is a volume marking that exists because insulin happens to come at 100 units per ml.

Correct me if the detail matters more than I have assumed.

DataDave said:

Do it in two steps and it stops being confusing.

Agreed, and it is worth saying that rounding to the nearest whole unit is usually acceptable at maintenance doses and is not acceptable at the bottom of a ladder, where one unit can be a fifth of the intended dose.

Dr.ReproEndo said:

I reconstituted a 10mg vial with 2ml of bacteriostatic water and I want someone to check my unit arithmetic before I draw anything, because I keep…

This matches mine closely enough to be worth saying so. Concentration choice is a precision decision, not a preference. Reconstitute high and every dose is a tiny volume where one unit of syringe error is a large fraction of the dose. Reconstitute low and you get more graduations per dose, so the same hand tremor costs proportionally less. Against that, more diluent means more benzyl alcohol and a shorter comfortable in-use window.

Adding the clinical framing, because it changes how the question reads.

Quick syringe math for dosing arithmetic dosing: if your vial is reconstituted at 5mg/2mL, that's 2.5mg/mL. For a 0.25mg dose you need 0.1mL = 10 units on an insulin syringe.

I keep a chart on my fridge:

• 0.25mg = 10 units
• 0.5mg = 20 units
• 1.0mg = 40 units
• 1.25mg = 50 units

Always double-check your concentration before drawing up!