🍪 The GLP Lounge uses cookies to improve your experience, analyze traffic, and personalize content. By continuing to use this site, you agree to our Cookie Policy.
Evidence-based GLP-1 & peptide discussion since 2023
ForumsCOA & Analytical TestingRed flags on COAs — how to spot a fake certificate

Red flags on COAs — how to spot a fake certificate

COA_Karl Sun, Jun 7, 2026 at 9:13 PM 5 replies 130 viewsPage 1 of 1
COA_Karl
Senior Member
2,123
8,901
Jan 2024
Pennsylvania
Jun 7, 2026 at 9:13 PM#1

Flagging this early and with the caveat that I may be wrong about part of it. I would rather be corrected than quiet.

Eight months with one supplier, then a change in how they communicate that I noticed before I noticed anything about the product.

One flattering data point from a group buy is not consistency. Consistency means separate batches, separately commissioned, over months.

What to check: Red flags, in rough order of how much they should worry you: no verifiable address, no batch numbers, prices far under market, vendor-commissioned tests only, pressure toward irreversible payment, and shipping with no temperature control.

If your experience contradicts this, say so in the thread — I would rather be corrected here than have people act on a warning that does not hold.

36 6matt_MKE, Dr.ReproEndo, lucas_SP_BR and 33 others
Reply Quote Save Share Report
Dr.BariatricHTX
Senior Member
1,456
7,234
Feb 2024
Houston, TX
Jun 7, 2026 at 9:21 PM#2
COA_Karl said:
Eight months with one supplier, then a change in how they communicate that I noticed before I noticed anything about the product.

No disagreement with COA_Karl. One condition attached. Prices dramatically below market are the strongest single signal, and the reason is arithmetic rather than suspicion. Synthesis, testing, and cold-chain shipping have floors. A price well under the floor means something was skipped, and the two things that get skipped are testing and content.

35 5pete_RVA, CarlaRPh_TPA, steph_laguna and 32 others
Reply Quote Save Share Report
Dr.NutriCornell
Senior Member
1,345
6,234
Mar 2024
Ithaca, NY
Jun 7, 2026 at 9:29 PM#3
COA_Karl said:
Eight months with one supplier, then a change in how they communicate that I noticed before I noticed anything about the product.

I disagree that testing history is decisive. It tells you what a supplier did when they were being watched. Continuity of behaviour under stress — a late shipment, a failed test, a complaint — is more predictive than any run of good results.

34 4laura_annarbor, JenMemphis, pat_auckland and 31 others
Reply Quote Save Share Report

Sigma-Aldrich — Research-Grade Standards

Certified reference materials, analytical reagents, and research-grade standards for peptide verification. Trusted by laboratories worldwide.

Shop Reference Standards
TinaHashiRN
Member
345
1,567
Sep 2024
Raleigh, NC
Jun 7, 2026 at 9:37 PM#4

Answering the narrow version, because the broad one does not have a single answer. The pattern that distinguishes a bad batch from an exit is behaviour rather than product. A bad batch comes with communication, a reshipment offer and a batch number. An exit comes with slower replies, pressure toward less reversible payment methods, sudden discounting, and the same reassurance repeated without any new information. The product tells you less than the correspondence does.

33 3Admin, Dr.Martinez, mike_mod and 30 others
Reply Quote Save Share Report
paige_pharma
Member
289
1,234
Sep 2024
Omaha, NE
Jun 7, 2026 at 10:18 PM#5
Dr.BariatricHTX said:
Prices dramatically below market are the strongest single signal, and the reason is arithmetic rather than suspicion.

Same position here, arrived at the long way round. One addition: an unstated method makes a report close to uninterpretable. "99% pure" without the technique, the standard and the conditions is a claim, not a measurement.

32 2lucas_SP_BR, lisa_labSD, adam_van and 29 others
Reply Quote Save Share Report

Similar Threads

HPLC vs UPLC for peptide purity — method comparison study18 replies
Mass spectrometry for peptide identity verification — ESI-MS guide7 replies
Endotoxin testing methods — LAL vs recombinant Factor C17 replies
USP reference standards for peptide verification — sourcing guide3 replies
Janoshik vs in-house testing — third-party verification importance18 replies
ForumsNewTrendingMembersAccount

Log In

Forgot password?
No account? Register